![]() I run ccleaner after rebooting then install Corsair again. ![]() If it asks if you want to remove any profiles or config files let it, then reboot. You can do a repair or uninstall from the Corsair installer you use to install the software. Reinstalling Icue / Clink4 also has helped. Next device manager in the usb section at the bottom look for a corsair entry.Īt 1 time I don't remember if h100iv2 or the h110i, but pretty sure it was CLINK4 after an update needed that device to be re-enabled then worked correctly again. The next thing I would check is the usb connections. ![]() If he has followed the instructions and has it set right he should have control over his fans and have fan speeds, pump speed, Temp info. Using the presets I always set the pump speed to max which can be labeled differently between which cooler / software it is.įans Balanced / Performance gives a good range to cover what is being done at the time, Browsing, Gaming, Cpu intensive work but are all still based off of the coolant temp. ![]() It makes for a little fun trying to set a custom curve of fans speeds when the temps are based off the coolant temp vs Cpu temp to have the fans react the way they need to.Ĭheck those settings to see if you can or can not adjust the fans. It can be set to the cpu temp but my fans reacted to the ryzen temp spikes. I now just plug my rear exhaust fan to it and set a custom curve in bios for approx 950ish rpm across all temps, but always monitor cpu temp with Icue, Hwinfo64, Or RM.ġ thing people do not realize, is the temp reading in Icue / CLink4 is the coolant temp not the Cpu temp by Default (which in his case would be the H115 coolant). I set that header to ignore and was JUMPED ON here on Th for doing so. On my Asus R S X470-F Gaming I hooked up my h110i per the instructions to boot it up to a cpu fan error. The 3 pin plug with the single wire is only a tach/sense wire that feeds the pump speed to the cpu_fan header (per instructs) or to another header which I found out. Some units can control each fan independently and on some control both fans but only 1 rpm reading. ![]() On the corsair units I have ran of the i series max pump speeds range from 2750-3000rpm. ![]()
0 Comments
Leave a Reply. |